Find out how to repair your heater, instead of replacing it for a costly price.
Use this guide to discover 10 signs your heater isn’t working properly and how to fix each issue.
Start by checking to see if any of the vents are fully or partially blocked.
Credit:Viktoriya Skorikova/Getty Images
A blockage could prevent the heater’s air from entering the home, causing temperature inconsistencies.
If you notice any obstructions, flush the area to allow for proper airflow.
Next, check the air filter, especially if it hasn’t been replaced recently.
A dirty filter can restrict airflow and reduce the appliance’s heating capabilities.
If these methods do not work, you may need to call an HVAC technician for professional help.
Next, inspect the air filter and replace it if it has not been recently replaced.
The issue could also be brought on by a blockage or leaks in the ductwork.
Clear any clogs you find in the condensate drain line to fix the issue.
Call an HVAC technician if these repairs don’t fix the problem.
If this is the case, replace the filter and clean the vents to address the issue.
Another reason for increased heating bills is if there is a problem with the thermostat.
This could cause the heater to cycle on and off unnecessarily, leading to a waste of energy.
Homeowners can fix these issues byadjusting the thermostat settingsor investing in a new one.
Filters will naturally become clogged over time, which can reduce the heater’s efficiency.
Hire an insulation professional toinsulate the rooms properlyto prevent unnecessary heat loss.
Start by checking that the thermostat is turned on and that it is on the heat setting.
Next, check the breaker switch for the heater.
If this does not work, then the issue may be the gas supply.
Check the gas supply in the home by testing other gas-using appliances.
If the air filter has not been recently switched, then take the opportunity to replace it.
Thermostat Malfunctions
A malfunctioning thermostat can cause a lot of issues when it comes to heating the home.
If the thermostat is set to cool, then it will not trigger the heater to turn on.
Additionally, you should replace the old batteries in the thermostat with a fresh set.
If the heater is not igniting, then it will be unable to produce heat for the home.
fire up the access panel on the furnace and locate the pilot light assembly reset switch.
Hold the reset button or use a long match to relight the pilot light.
Then, use compressed air to dust off the ignitors and put the panel back in place.
Lastly, restore power and the gas supply to the heater.
If this does not work, you might need an HVAC professional to inspect and repair the problem.
A dirty flame sensor could lead to false readings, causing the heater to shut down intermittently.
Contact an HVAC professional if the issue persists.
