Give your bed a new look when you reupholster the headboard.
Your headboard, for example, can easily be transformed with just a few hours of upholstery work.
An upholstered bed will put a modern, clean twist on a dated bed frame.
And the best part?
You don’t need to be an accomplished seamstress to do this project.
Check out the rest of this weekend bedroom makeover.
Without this layer, whatever you’re upholstering will look flat, harsh, and uncomfortable.
Start by laying the bed pieces on a clean floor and placing upholstery foam over each piece.
double-check the front of each surface is covered.
Next, use a serrated bread knife to cut the foam to the shape of the furniture.
Use double-sided carpet tape to adhere the foam to the bed pieces.
verify all edges are properly secured.
Cut Batting to Size
The next step is to wrap each piece in batting.
This layer beneath the fabric is what gives an upholstered headboard its fluffy, soft edges and cushiony touch.
If you want an extra plush look, double up the batting layers.
Place the batting over each piece of the bed topped with upholstery foam.
First, cover a 1-foot section of the batting with spray adhesive.
Carefully press onto the upholstery foam in place and hold for a few seconds.
Continue spraying and placing the batting until the entire surface is covered.
Put the staples about an inch away from the edge of the board to keep the batting taut.
Lay the fabric on the floor or table with the pattern side down.
Place the bed frame pieces on top of the fabric and begin folding over the excess fabric.
Hold taut and use a staple gun to secure the fabric over the batting.
Be sure to staple close to the edge and place staples 3-5 inches apart.
Remember to avoid placing fabric too close to screw holes or joints where the headboard pieces meet.
If necessary, use fabric fuse glue on any of the fabric’s exposed edges to prevent fraying.
Reassemble Bed Frame
Finally, reassemble the upholstered headboard, side rails, and footboard back together.
Reference the photo from the first step to ensure the pieces are properly secured.
